MONIT RALLY INSTALLATION FOR 2-WIRE ABS SENSOR
€50.90
Tax included
Monit Rally wiring for probe through ABS sensor
Secure payment
Shipping and returns
This Monit Rally electrical installation takes the signal produced by an ABS wheel speed sensor and converts it into a format that can be used as information for a Monit Rally tripmaster.
It works with most types of two-wire sensors that generate an analog output signal.
It can only be used with ABS wheel speed sensors that have been disconnected and are no longer used by the vehicle's safety systems. It should not be installed in any vehicle that continues to use its ABS system.
TECHNICAL SPECIFICATIONS:
Hysteresis voltage: 200 mV
Maximum input frequency: 4 kHz
Input impedance: 100 Kohm
Operating temperature: -20 to 125 ºC
It works with most types of two-wire sensors that generate an analog output signal.
It can only be used with ABS wheel speed sensors that have been disconnected and are no longer used by the vehicle's safety systems. It should not be installed in any vehicle that continues to use its ABS system.
TECHNICAL SPECIFICATIONS:
Hysteresis voltage: 200 mV
Maximum input frequency: 4 kHz
Input impedance: 100 Kohm
Operating temperature: -20 to 125 ºC
Comments (0)
No customer reviews for the moment.
Monit Rally wiring for probe through ABS sensor